Dismantle EC2T

• Take your pliers and carefully bend the metal back from each side of the card (left, right, top, bottom)
• Bend the metal back from beside the dongle connector
• Peel off the metal sides of the card (carefully, they're glued on pretty well, but it's not hard) 

    Be careful not to bend the circuit board inside, and since the metal is glued most strongly
    to the PCMCIA connector be especially careful when removing the metal from that part.

• Carefully remove the plastic from around the circuit board
• Use your handy-dandy electrical tape and cover the little capacitor and the pins that form the PCMCIA connector.  The idea here is to prevent any exposed metal from shorting to the chassis of the PCMCIA socket.  You can go crazy with the electrical tape if you want to, but it's not necessary.

Next: Solderin'!